ARKA myAqua Multifilter - 4000ml

Incl. inner cartridge and accessories
 

The ARKA myAQUA Multifilter 4000 is ideal for filling with resin/mixed-bed resin, absorbers and many other filter materials, such as e.g. B. activated carbon. Thanks to the built-in 1 inch water-neutral plastic thread and the included 1" to ¾" and ¼" transitions for the water inlet and outlet, it can be used universally both as a downstream resin filter on reverse osmosis systems and for many other purposes.

Furthermore, the standardized size of the filter housing of 20 x 4.5 inches offers the possibility of using a large number of different inner cartridges of this size.

The ARKA myAQUA Multifilter 4000 consists of high-strength, food-safe plastic (PP) and is pressure-resistant up to 28 bar. The double O-ring seal ensures maximum tightness.

The supplied refillable inner cartridge has built-in fine filters on both sides, so that no suspended matter gets into the inner filter and no abrasion or parts of the resin or filter material get out of the inner filter. The two loosely enclosed filter sponges can be used depending on the material used and the filling quantity.

All benefits at a glance:

• Filling volume: 4000 ml
• Multifunctional: can be filled with resin/mixed-bed resin, absorbers and many other filter materials, such as e.g. B. activated carbon
• Efficient, durable and reliable
• Easy to use
• Refillable
• Pressure-resistant up to 28 bar
• Maximum tightness
• Dimensions: ~ 61 x 18.5 x 18.5 cm

Installation:

• Install the included wall bracket as shown above and screw the ARKA myAQUA Multifilter 4000 to it. Make sure the screws are tight and properly tightened.
• Now remove the main body of the multi-filter using the enclosed filter cartridge wrench.
• Remove the refillable cartridge inside and open it by unscrewing the upper screw cap.
• Fill the inner cartridge with the desired material, screw the lid back on and put it back into the filter housing.
• Then screw the base body back onto the filter cover using the filter cartridge wrench. Important: Make sure that the screw connection between the housing and the cover is tight.
• Now connect the water source and a hose for the drain to the marked water inlets and outlets. Make sure the connected hoses are seated correctly and tightly, as well as the markings for the water inlet (IN) and water outlet (OUT).

REGARD:

• If you want to use the enclosed transitions, make sure that the seals or O-rings are inserted. Alternatively, the thread sides can be wrapped several times with the enclosed Teflon tape.
• If you use the supplied ¾" to ¼" transitions, you must remove the blue safety rings before inserting the hose and press the mount down. Once the hose is plugged in, the locking rings must be put back on.
• To vent the housing, press and hold the red vent button on top of the filter cover until water comes out of it.

IMPORTANT:

Use the supplied wall bracket or otherwise ensure that the ARKA myAQUA Multifilter 4000 is stable to prevent it from tipping over.
Note the maximum pressure resistance of 28 bar.
We recommend using the two filter sponges supplied loose.